FORD 2010 Explorer v.1 - Manual (Page 135)

Programming
Do not program HomeLink
௡ with the vehicle parked in the garage.
Note: Some vehicles may require the ignition switch to be turned to the
accessory position for programming and/or operation of the HomeLink
௡.
It is also recommended that a new battery be placed in the hand-held
transmitter of the device being programmed to HomeLink
௡ for quicker
training and accurate transmission of the radio-frequency signal.
Console mount
Visor mount
1. Position the end of your hand-held transmitter 1–3 inches (2–8 cm)
away from the HomeLink
௡ button you wish to program while keeping the
indicator light in view.
2. Simultaneously press and hold both the chosen HomeLink
௡ and
hand-held transmitter buttons until the HomeLink
௡ indicator light
changes from a slow to a rapidly blinking light. Now you may release
both the HomeLink
௡ and hand-held transmitter buttons.
Note: Some entry gates and garage door openers may require you to
replace Step 2 with procedures noted in the Gate Operator and
Canadian Programming section for Canadian residents.
Driver Controls
135
2010 Explorer (exp)
Owners Guide (own2002), 1st Printing
USA (fus)