beautypg.com

Seating and safety restraints – FORD 2010 Edge v.1 User Manual

Page 146

background image

The driver and front passenger Belt-Minder

௡ features can be

deactivated/activated by performing the following procedure:

Before following the procedure, make sure that:
• The parking brake is set.
• The gearshift is in P (Park).
• The ignition is off.
• The driver and front passenger safety belts are unbuckled.

WARNING: While the design allows you to deactivate your
Belt-Minder

௡, this system is designed to improve your chances of

being safely belted and surviving an accident. We recommend you
leave the Belt-Minder

௡ system activated for yourself and others who

may use the vehicle. To reduce the risk of injury, do not
deactivate/activate the Belt-Minder

௡ feature while driving the vehicle.

1. Turn the ignition switch to the on position. DO NOT START THE
ENGINE.

2. Wait until the safety belt warning light turns off (Approximately
1–2 minutes).
• Step 3 must be completed within 50 seconds after the safety belt

warning light turns off.

3. For the seating position being disabled, buckle then unbuckle the
safety belt nine times at a moderate speed, ending in the unbuckled
state.
• After Step 3, the safety belt warning light will be turned on for three

seconds.

4. Within approximately seven seconds of the light turning off, buckle
then unbuckle the safety belt.
• This will disable the Belt-Minder௡ feature for that seating position if it

is currently enabled. As confirmation, the safety belt warning light will
flash four times per second for three seconds.

• This will enable the Belt-Minder௡ feature for that seating position if it

is currently disabled. As confirmation, the safety belt warning light will
flash four times per second for three seconds, followed by three
seconds with the light off, then followed by the safety belt warning
light flashing four times per second for three seconds again.

Seating and Safety Restraints

146

2010 Edge (edg)
Owners Guide (own2002), 1st Printing
USA
(fus)