beautypg.com

Replacing interior bulbs, Replacing exterior bulbs, Replacing headlamp bulbs – FORD 2011 Fusion Hybrid v.2 User Manual

Page 84: Replacing front parking lamp/turn signal bulbs, Replacing front side marker bulbs, Replacing tail/brake/turn signal/backup lamp bulbs, Lights

background image

Replacing interior bulbs

Check the operation of all bulbs frequently.

Replacing exterior bulbs

Check the operation of all the bulbs frequently.

Replacing headlamp bulbs

For bulb replacement, see your authorized dealer.

Replacing front parking lamp/turn signal bulbs

For bulb replacement, see your authorized dealer.

Replacing front side marker bulbs

1. Make sure the headlamp control
is in the off position.

2. Remove the press pins located in
the wheel well and pull the splash
shield back.

3. At the wheel opening, remove the
bolt and pull the lamp away from
the vehicle.

4. Rotate the socket clockwise while
holding the electrical connector in
place with your other hand. Disengage the wire harness and bulb from
the lamp.

5. With the bulb exposed, carefully remove the bulb from the socket by
grasping the bulb and pulling it away from the wire harness.

Replace with a new bulb, and reverse the removal steps to complete the
process.

Replacing tail/brake/turn signal/backup lamp bulbs

The tail/brake/turn signal and backup lamp bulbs are located in the tail
lamp assembly. Follow the same steps to replace either bulb.

1. Make sure the headlamp switch is in the off position and open the
trunk.

2. Lift out trunk floor carpeting panel to access a luggage scuff plate
(hard molding) and a trunk side panel (dark grey, soft wheelhouse side
trim panel) at the lamp area.

3. Carefully pull/push the trunk side panel (dark grey, soft wheelhouse
side trim panel) outboard to expose the lamp assembly. The most

Lights

84

2011 Fusion Hybrid (hfv)
Owners Guide, 2nd Printing
USA
(fus)

This manual is related to the following products: