beautypg.com

Heated outside mirrors, Signal indicator mirrors (if equipped), Blind spot mirrors – FORD 2012 Expedition v.2 User Manual

Page 93: Driver controls

background image

The power-folding mirrors may be moved inward/outward manually.
However, if a mirror is moved manually, it will need to be reset. A mirror
which has not been reset may appear to be loose. To reset: with the
switch in the center position, momentarily pull the switch rearward to
fold the mirrors in. An audible

ЉclickЉ will be heard indicating

re-synchronization. If the click is not heard, use the switch to fold the
mirrors out, then in, until the click is heard. After that, the mirrors will
operate normally until they are again moved manually.

Note: 10 or more switch activations within one minute, or repeated
folding/unfolding of the mirrors while holding the switch rearward during
full travel, may cause the system to disable the fold/unfold function to
protect motors from overheating. Should this occur, wait approximately
three minutes with the vehicle running and up to 10 minutes with the
vehicle off, for the system to reset and for function to return to normal.

Heated outside mirrors

Both mirrors are heated
automatically to remove ice, mist
and fog when the rear window
defrost is activated.

Do not remove ice from the
mirrors with a scraper or
attempt to readjust the mirror
glass if it is frozen in place.
These actions could cause damage to the glass and mirrors.

Do not clean the housing or glass of any mirror with harsh
abrasives, fuel or other petroleum-based cleaning products.

Signal Indicator Mirrors (If Equipped)

When the turn signal is activated,
the lower portion of the mirror
housing will blink.

Blind spot mirrors

Your vehicle is equipped with blind spot mirrors. Refer to Blind spot
mirrors
in the Driving chapter.

Driver Controls

93

2012 Expedition (exd)
Owners Guide, 3rd Printing
USA
(fus)

This manual is related to the following products: