Clearing a homelink? device, 174 universal garage door opener (if equipped) – FORD 2013 Taurus v.2 User Manual
Page 174

Programming HomeLink
姞
to the Genie Intellicode
姞
garage door
opener motor
Note:
You may need a ladder to access the garage door opener motor.
To program HomeLink
威
to the
garage door opener motor.
1. Press and hold the PROGRAM
button on the garage door opener
motor until both blue LED’s turn on.
2. Release the PROGRAM button.
Only the smaller round LED should
be on.
3. Press and release the program button. The larger purple LED will flash
Note:
The next two steps must be completed in 30 seconds.
4. Press and release the Genie Intellicode 2 hand-held transmitter’s
previously programmed button. Both indicator lights on the garage door
opener motor unit should now flash purple.
5. Press and hold the previously programmed button on the sun visor for
2 seconds. Repeat this step up to 3 times until the garage door moves.
Programming is now complete.
At this point, programming is complete.
Clearing a HomeLink
姞
device
To erase programming from the three HomeLink
威
buttons, press and
hold the two outer HomeLink
威
buttons until the indicator light begins to
flash. The LED will begin flashing in 10 to 20 seconds, at which time
both buttons should be released. Programming has now been erased, and
the led should blink slowly to indicate the device is in train mode when
any of the three HomeLink buttons are pressed.
174
Universal Garage Door Opener (If Equipped)
2013 Taurus
Owners Guide gf, 2nd Printing
USA
(fus)