beautypg.com

Locks – FORD 2014 F-150 Raptor v.3 User Manual

Page 62

background image

3. Enter your personal 5-digit code. You

must enter each number within five
seconds of each other.

4. Press 1·2 on the keypad to save

personal code 1.

The doors will lock then unlock to confirm
that programming was successful.

To program additional personal entry
codes, repeat Steps 1-3, then for Step 4:

Press 3·4 to save personal code 2.

Press 5·6, 7·8 or 9·0 to save personal
code 3.

You may also program a personal entry
code through the MyFord Touch system.

Tips:

Do not set a code that uses five of the
same number.

Do not use five numbers in sequential
order.

The factory-set code will work even if
you have set your own personal code.

Recalling Memory Positions (If
Equipped)

The programmed entry codes will recall
driver memory positions as follows:

Entry code 1 will recall driver 1 memory
positions.

Entry code 2 will recall driver 2 memory
positions.

Note: Personal entry codes 3, 4 and 5 will
not recall memory positions.

Erasing a Personal Code

1.

Enter the factory-set 5-digit code.

2. Press and release 1·2 on the keypad

within five seconds.

3. Press and hold 1·2 for two seconds.

You must do this within five seconds
of completing Step 2.

All personal codes will erase and only the
factory-set 5-digit code will work.

Anti-Scan Feature

The keypad will go into an anti-scan mode
if you enter the wrong code seven times
(35 consecutive button presses). This
mode disables the keypad for one minute
and the keypad lamp will flash.

The anti-scan feature will turn off after:

One minute of keypad inactivity.

Pressing the unlock button on the
remote control.

Switching the ignition on.

Unlocking and Locking the Doors

To Unlock the Driver Door

Enter the factory-set 5-digit code or your
personal code. You must press each
number within five seconds of each other.
The interior lamps will illuminate.

Note: All doors will unlock if you disable
the two-stage unlocking mode. See
Locking and Unlocking (page 57).

To Unlock All Doors

Enter the factory-set code or your personal
code, then press 3·4 within five seconds.

To Lock All Doors

Press and hold 7·8 and 9·0 at the same
time (with the driver door closed). You do
not need to enter the keypad code first.

Displaying the Factory Set Code

Note: You will need to have two
programmed passive anti-theft keys for this
procedure.

To display the factory-set code in the
information display:

1.

Insert a key into the ignition and switch
the ignition on for a few seconds.

59

F150 (TF6) , enUSA

Locks

This manual is related to the following products: