Tire repair with the m mobility system – BMW M3 Convertible 2005 User Manual

Page 143

143

Using the M Mobility system

To repair a flat tire using the M Mobility
system, proceed as follows:
> Fill with sealant, refer to page

143

> Distribute the sealant, refer to

page

143

> Restore tire inflation pressure, refer

to page

143

Filling with sealant

1. Shake the bottle of sealant
2. Screw hose 9 onto the opening of

the sealant bottle

3. Twist the dust cap off of the valve on

the flat tire and screw filler hose 2
connected to the sealant bottle onto
the valve

4. Insert the sealant bottle into the con-

nector on the compressor so that it is
standing upright

5. Make sure that the system is

switched off, position 0

6. Insert connector 3 into the cigarette

lighter socket inside the vehicle, refer
to page

101

7. When using the version with the

manometer on the hose: make sure
that screw 8 on the manometer is
tightened down

8. With the ignition key in position 2:

Switch on the compressor and keep
it running for approx. 3 minutes to fill
in the sealant. It does not matter
afterward, what the tire's inflation
pressure is

9. Turn the system off and disconnect

the hose from the sealant bottle and
the wheel valve. Stow the M Mobility
system in the vehicle.

Distributing the sealant

Right afterward, drive at least about
2 miles / 3 km, so that the sealant is
distributed evenly in the tire.

Do not exceed a maximum speed
of 35 mph / 60 km/h. If possible,

keep the vehicle speed above 12 mph /
20 km/h.

Inflating tire to correct pressure

1. After driving approx. 1.9 miles/3 km,

pull over at a suitable location

2. Screw hose 9 connected to the com-

pressor directly onto the tire valve

3. Insert connector 3 into the cigarette

lighter socket inside the vehicle

Tire repair with the M Mobility system

Overview

Controls

Maintenance

Repairs

Data

Index