FASS FA D05 220G - Manual (Page 8)

C. Route wire harness along frame to the approximate mounting location near the fuel tank. Completion of
this step will be addressed in the Step 3.
B. Secure Relay in an upright position, as shown, to prevent moisture from entering. Di-electric grease
may be applied to prevent corrosion.
A. Disconnect the battery before beginning installation. Using ring termi-
nals, attach red wire of the WH-1004 to the positive battery terminal.
The use of corrosion preventative spray is recommended. Attach
green wire to a clean ground, preferably the negative battery terminal.
Secure fuse block in a location protected from outside elements.
The installation of the electrical harness is done first, allowing power to be applied to the pump for
lubrication purposes later in the installation.
Note: The FASS harness provided has a 15 amp fuse and the 30 amp fuse provided
loose in the kit is to be installed on the wiring harness due to the volume and torque
the FASS pump is producing.