FASS T 260G User Manual
Page 10
Some of the photo’s are of a different application, procedures are the same.
D.
Position system where it will be mounted. Mark the (4) mounting
points (using the template located on the contents page). Prior holes may be used. Drill these
marked locations with a 13/32 bit.
C.
Attach BR-2001 to back of system using the spacers and 1/4” bolts. Use the two bottom bolts and the
very top one bolt opening.
G.
Apply motor oil to O-rings located on filters. Attach to system and tighten appropriately
E.
Connect factory plug into the FASS harness. Turn key to “on”. With pump operating, turn pump over,
liberally spray WD-40 (or equivalent) into water separator nipple lubricating the Gerotor.
F.
Assemble to frame using the (4) - 3/8” bolts & flange nuts placing the RS-1001 between the frame and
bracket.
- T D07 095G (20 pages)
- T D07 220G (20 pages)
- T D08 095G (19 pages)
- T D08 220G (21 pages)
- T D09 095G (19 pages)
- T D10 125G (20 pages)
- T D02 095G (19 pages)
- T F17 125G (21 pages)
- T F17 200G (21 pages)
- T F17 220G (21 pages)
- T F16 095G (19 pages)
- T F16 220G (20 pages)
- T F16 260G (20 pages)
- T F14 125G (21 pages)
- T F14 200G (21 pages)
- T F14 220G (21 pages)
- T C11 095G (20 pages)
- T C10 095G (20 pages)
- T C10 220G (21 pages)
- T 095G (23 pages)
- T 220G (23 pages)
- T UIM 150G (23 pages)
- T UIM 220G (23 pages)
- T UIM 260G (23 pages)
- T 080G (23 pages)
- T 125G (23 pages)
- T 200G (23 pages)
- FA D05 095G (16 pages)
- FA D05 220G (16 pages)
- FA D05 260G (16 pages)
- FA D07 095G (16 pages)
- FA D07 220G (16 pages)
- FA D07 260G (16 pages)
- FA D08 095G (16 pages)
- FA D08 220G (18 pages)
- FA D08 260G (18 pages)
- FA D09 095G (15 pages)
- FA D10 125G (18 pages)
- FA D10 220G (19 pages)
- FA D10 240G (19 pages)
- FA D02 095G (15 pages)
- FA F17 125G (19 pages)
- FA F17 200G (19 pages)
- FA F17 220G (19 pages)