FASS T 220G - Manual (Page 17)

B. Secure female end in vise.
D. The male portion should tightened all the way, as seen.
A. Assemble fuel line into female hose fitting (reverse threads), then
apply a modest amount of oil to the interior lining.
C. Oil male JIC swivel (90° or straight) and assemble into female end.
Caution: Do Not use sealant on AN fittings. Only use sealant on threads installed into pump assembly or joining fittings.
These lines must be the exact length on both sides.
Return line from
FASS with straight
ends to cross member
where the line will
“T” off.
E. Assemble the “T” using (1) 3/8 NPT ‘T’, (2) -8 ANx3/8 MPT & (1) -8 ANx3/8
MPT 90° as seen in the photo.
From “T” to each fuel tank with
2-straight fittings on 2 of the lines going to the Vent Line &
1-90° fitting on Return line connecting to the FASS