Chicago Electric PORTABLE GENERATOR 98452 User Manual
Page 18
Page 18
SKU 98452
For technical questions, please call 1-800-444-3353.
When finished using the Generator, turn the Engine Power Switch (2) to its
5.
“OFF”
position. Turn the Fuel Valve (40B) to its
“OFF” position. Then, disconnect the
electrical powered tool or equipment from the Generator’s DC Terminals (7).
(See Figure h.)
After the Engine and Generator have completely cooled, store the Generator in a
6.
safe, clean, dry location (if not already installed in one).
NOTE
7.
: The Generator features a 10 AMP DC Fuse (9) to protect the DC circuit in
case of an overload. Should an overload occur the Fuse will burn out, causing the
Genrator to automatically shut down. In this case, refer to Step #1 in this section.
Then, reset the circuitry system by replacing the burnet Fuse with a new 10 AMP
DC Fuse. Restart the Generator and continue powering the remaining tool or
equipment.
(See Figure h.)