Step 2. set water hardness number, Step 3. set recharge (regeneration) time – EcoPure MW_MW30_7337539A User Manual

Page 18

Miracle Water Installation & Operation Manual

Step 2. Set Water Hardness Number

1. Press the (Select/Menu) button once to display a flashing 25 and HARDNESS.

2. Press the UP p or DOWN q buttons to set your water hardness number.
NOTE: Be sure to enter the grains per gallon (gpg) hardness of your water supply on page

4, for future reference. If your water supply contains iron, compensate for it by

adding to the water hardness number. For example, assume your water is 20 gpg

hard and contains 2 ppm iron. Add 5 to the hardness number for each 1 ppm of

iron. In this example, you would use 30 for your hardness number.

20 gpg hardness

2 ppm iron x 5 = 10

+10

(times)

30 HARDNESS NUMBER

Step 3. Set Recharge (Regeneration) Time

1. Press the (Select/Menu) button once to display a flashing 2:00AM and RECHARGE

TIME.

If no change is desired, go to Step 4. If you want to change the recharge start time, press the

UP p or DOWN q buttons until the desired starting time shows.

SELECT