Dogtra 2300 Series User Manual

Page 15

Battery Charging Procedure

Note : The unit has a partial charge when it

leaves the Dogtra facility, upon receipt of
the collar, be sure to give it a full 2-hour
initial charge before the first use.

1. Attach the charging cables to both the

transmitter and receiver(s), as shown on
page 26.

2. Plug the charger into a 120-volt wall outlet

or, if using the accessory field charger, plug
into a cigarette lighter only for Lithium-
Polymer battery. (Use a 230-volt European

CHARGING THE BATTERIES

Recharge the unit if :

The indicator light on the collar is emitting a
red color.

If the 3 bar indicator on the transmitter LCD
shows just 1 bar.

The indicator light on the transmitter or
receiver will not come on.

The indicator light on the transmitter or
receiver comes on momentarily, but will not
stay on when the “Constant” button is pushed.

CHARGING THE BATTERIES

charger for Europe.) When properly plugged
in, all indicator lights should glow red. During
the charging process, the unit will shut off.
Once the battery cable is unplugged from the
unit after a full charge, you will need to turn
the unit on again before use.

3. The Lithium-Polymer battery is fully charged

within 2 hours. The lights will stay red during
the charging process. The red light will change
into a steady green light when the battery is
fully charged. (When you disconnect the
charger after finishing the charge, you will
need to restart the units).

4. After charging, cover the battery charging

receptacles with the rubber plugs on the
transmitter and receiver.

NOTE : Only use Dogtra-approved batteries,

chargers, and accessories for your
Dogtra e-collars. When a charger is not
in use, disconnect it from the
power source.