Perations, Getting ready – Bissell 23V8E User Manual
Page 7
w w w. b i s s e l l . c o m
7
O
perations
1a
1b
getting ready
the mop pad may have already
come attached to the mop head, if
not follow steps 1a and 1b below.
1. Attach mop pad
a.
Set mop head in mop pad, making
sure toggle is located on the back.
b. Tighten mop pad by pulling on elastic
cord while pressing on toggle.
2. Fill the water tank
a. Remove tank by lifting straight up
and away from unit.
b. Unscrew cap at bottom of water tank.
c. Fill water tank with water. For best
results, water should be at
room temperature.
d. Replace the cap, tighten until snug.
e. Replace water tank by gently sliding
tank into place.
3. Twist the quick release cord wrap clock-
wise to unwrap the power cord completely
and plug into a 220-240 Volt outlet as
described on the important safety
instructions, page 3.
4. The indicator light will illuminate when the
Steam Mop Select is plugged in.
2a
2d
2b
2e
Tip:
Use of distilled water is recommend-
ed to prolong the life of your Steam
Mop Select