COBY HDR-700 - Manual (Page 15)

Page 1 Coby Electronics Corporation www.cobyusa.com Page 1
getting Started
Connecting Power
Connect the HDR-700 to an AC 100-240V wall outlet to
charge its internal battery or to operate the unit from AC
power.
Plug one end of the supplied power adapter to the DC
12V Power Input Jack located on the rear of the unit.
Plug the other end into an AC 100-240V wall outlet.
It will take approximately 8 hours to fully charge the
internal battery.
The battery used in this device may present a fire
or chemical burn if mistreated. Do not disassemble,
incinerate, or heat the battery.
Do not connect this unit to a power source other than
that which is indicated here or on the label as this
may result in the risk of fire or electric shock.
Use only the AC adapter supplied. Failure to do so
may cause a fire or damage the unit.
Upon initial use, the battery should be charged fully
(~8 hours) to ensure optimal performance and bat-
tery life.

