Bissell Powerforce bagless turbo 28F4 series - Manual (Page 6)

w w w. b i s s e l l . c o m
O
perations
6
Handle position
Press the handle release pedal with
your foot to place your BISSELL
Powerforce Pet into one of three
cleaning positions.
1. Upright- For storage and above floor
cleaning with special tools.
2. Normal Cleaning- Press handle release
pedal once. Use for most household floor
cleaning tasks.
3. Low Cleaning- With the vacuum in
normal cleaning position, press handle
release pedal again. Use for reaching
under low furniture such as tables, chairs
and beds.
Powerfoot height adjustment
The powerfoot/rotating floor brush
on your BISSELL Powerforce Pet
Cyclonic can be adjusted to clean
several floor surfaces.
NOTE: For optimal cleaning
performance, adjust to the lowest
practical setting. If your cleaner is
difficult to push, adjust to the next
higher setting.
1. Place handle in upright position.
2. Turn height adjustment knob to desired setting.
Lowest Setting - For bare floors.
Medium Settings - For short and medium
pile carpets.
Highest Setting - For plush pile carpets.
3. Place the handle into the normal cleaning
position and the powerfoot will adjust to
the setting chosen.
NOTE: You may also adjust the
setting while in the normal cleaning
position.
Transporting cleaner
1. To move your cleaner from room to room,
put the handle in the upright position, tilt the
cleaner back on its rear wheels and push
forward.
2. The cleaner can also be moved by using
the carrying handle on the back.
1
2
3
CAUTION:
Before using your vacuum, make sure
that the dirt container is in locked
position and that all filters (inner circular,
outer circular, pre-motor and post-
motor) are in place. Do not operate
your vacuum without these filters.
Tip:
Your vacuum
features a Quick
Release cord
wrap. To remove
the power cord
quickly and eas-
ily, rotate the
upper cord wrap
towards the floor,
and slip power
cord from upper
and lower
cord wraps.
Tip:
Before cleaning
under low furni-
ture, check area
first for objects
that might harm
the unit or block
the vacuum hose.
ATTENTION:
Some Berber carpets have a tendency to
fuzz with wear. Repeated strokes in the
same area may aggravate this condition.
Consider setting your cleaner on a higher
than normal setting for this type of carpet.
Carrying
Handle