beautypg.com

Warning, Notice, Aintenance and care 12 – Bissell 10N6 User Manual

Page 12

background image

1.

Unplug the vacuum from electrical outlet.

2.

The pre-motor filter protects the motor from

dirt particles. It is located in the slide out

tray underneath the dirt container. If the filter

becomes dirty, pull out the tray, lift out the

foam filter pad and clean it.

NOTE: The pre-motor filter may be hand washed

in cold water with mild detergent. Rinse well

and air dry thoroughly before replacing.

3.

The post-motor HEPA media filter assists in

the filtration process to return clean air to

the room. It is located behind the door on the

side of the vacuum. If the filter becomes dirty,

remove the door, remove the filter and replace.

NOTE: The post-motor filter is a

white, pleated HEPA media filter. This

filter is not washable and must be

replaced when it becomes dirty.

Check rotating floor brush and drive belt

You should check your vacuum cleaner’s rotating floor

brush and drive belt regularly for wear or damage. You

should also clean the brush and brush ends of strings,

hair and carpet fibers. This type of debris can wrap

around the brush and hamper its ability to effectively

clean your carpet. Also remove any debris that has

accumulated under the brush cover.

1.

Unplug the vacuum from electrical outlet.

2.

Place handle in low position and turn vacuum

cleaner over so bottom side is facing up.

3.

Remove the two screws marked 2 and 4.

Once the screws are removed, lift tab 1 and

release the three latches in order marked

2 - 4 marked. Lift off the brush cover

4.

Grasp rotating floor brush at both ends and lift.

5.

Clean strings, hair and other debris from

rotating floor brush, paying particular

attention to brush ends.

6.

Clean strings, hair and other debris from

motor pulley and drive belt areas.

M

aintenance and care

12

w w w . b i s s e l l . c o m

3.

WARNING:

To reduce the risk of injury

from moving parts, turn

vacuum cleaner off and

disconnect power plug

from electrical outlet.

1

2

3

4

Cleaning the pre-motor and post-motor HEPA media filter

Post-Motor

HEPA

Media

Filter

Washable

Pre-Motor

Filter

WARNING:

Do not operate cleaner

with damp or wet filters or

without all filters in place.

NOTICE:

This product is intended for

household use only and not

for commercial or industrial

use. Vacuuming of dust from

products like plaster, concrete

or ashes will damage the motor

and void the warranty.

This manual is related to the following products: