Bissell 34T2E - Manual (Page 13)

13
O
perations
ReadyTools™ continued
5. Vacuum thoroughly to pick up loose
debris and pet hair. Use a vacuum with
a brush attachment and a crevice tool to
clean in fabric folds and tufts.
6. To begin cleaning with attachments,
follow the instructions on page 10 for
filling the 2-in-1 water tank.
7. Set the ReadyTools dial to the TOOLS setting.
This will allow spray and suction from the hose.
8. Attach the cleaning tool of your choice to
the end of the hose.
9. Clean by pressing the spray trigger to spray
solution onto the area to be cleaned. Slowly
move the tool back and forth over the soiled
surface. Release the spray trigger to suction dirty
water. Continue to clean in the area, working in
small sections, until dirt is removed.
Caution: Do Not Overwet.
10. When finished cleaning, remove and
rinse tool(s) in clean, running water.
11. It is recommended that you suction clean
water from the tap to rinse out the hose.
12. Before wrapping hose onto tool rack, lift
end of hose and stretch out to ensure all
water is cleared from hose.
13. Wrap flex hose around tool rack.
14. Empty 2-in-1 water tank and rinse out,
following instructions on page 12.
15. If the ReadyTools dial becomes difficult to
turn, the diverter assembly that holds the
dial may need to be cleaned. To clean, first
remove nozzle and locate screw that holds
the diverter assembly in place. With a Phillips
screwdriver, remove the screw and set aside.
16. Remove diverter assembly; hold under running
water making sure water flows through and
around the dial. Turn the dial about 10 times
clockwise and 10 more times counter
clockwise. This should free up any debris.
17. Wipe diverter assembly with a soft cloth and
replace back on machine. Replace nozzle.
18. Return ReadyTools dial to FLOOR
CLEANING setting.
7.
11.
15.
12.
16.
Run water through here
Screw