Bissell 1225E - Manual (Page 12)

pump belt removal & replacement
Occasional replacement of the pump belt may
become necessary. if needed, please follow
instructions below.
1. Turn off machine and unplug it from outlet.
Wrap hose and cord on racks.
2. Remove 2-in-1 water tanks and set aside.
3. iMPORTANT: Fully recline handle and turn
unit upside down.
4. locate red belt access door and remove
two screws.
notE: the dark screw is a long machine screw
and will take approximately 25 full turns to
completely remove. the head of the screw will
lift from the belt access door so that it can be
easily removed.
5. Remove belt access door assembly from end
of brush and set aside.
6. Remove brush belt from end of brush and
set aside. if worn or damaged, replace with new
brush belt.
7. Remove pump belt and replace it with a new
belt by pinching belt at one end to make a large
loop. Attach belt to silver motor shaft first and
then pull towards larger, red pulley. Attach belt
to red pulley.
notE: Spinning the red pulley a few times will
help center belt and ensure correct assembly.
8. Reattach brush belt by installing onto
toothed pump pulley and then onto toothed
end of brush.
9. Reattach belt access door assembly
to end of brush and rotate back into place.
Replace screws.
notE: Do not over tighten screws.
if you have any questions or are having trouble
removing, replacing or reinstalling your brush
belt, please call bissell Consumer Care.
Maintenance & Care
www.bissell.com
12
WaRnInG
To reduce the risk of electric shock, push power button
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
2. 3.
2 3
4 5
6 7
8 9
5.
7.
9.
4.
6.
8.