Bissell 1190B - Manual (Page 12)

machine care (check regularly)
cleaning suction gate
The suction gate automatically diverts air when
the portable deep cleaner is detached. This
should be checked and cleaned regularly for
any dirt and debris.
1. step on the pedal and remove the portable
spot cleaner. Remove dirty tank.
2. Remove two screws and pull off suction
gate door.
3. Wipe suction gate clean and rinse suction
gate door.
4. Replace suction gate door and two screws.
cleaning spray tips
1. step on the pedal and remove the portable
spot cleaner.
2. To remove black spray tip, unlatch tab on
front portion of spray tip from base of machine
and pull up and out of red receiver.
3. Clean by rinsing under water.
4. Replace black spray tip by inserting back
into red receiver and latching tab back down
into base of machine.
5. Repeat steps on second spray tip.
Small belt removal and replacement (as needed)
Occasional replacement of one or both belts
may become necessary. if that is needed, please
follow the instructions below.
1. Turn off the machine, and unplug it from
the outlet. Remove portable spot cleaner.
2. Remove the nozzle assembly from the
machine. Refer to step 2 on page 9.
3. Turn the machine on its side.
ImpoRtANt: with portable spot cleaning pedal
facing down.
4. Remove end cap by unscrewing the 3 screws.
Take care not to drop the screws into the unit.
5. Remove 1 silver screw from the pivot arm.
6. Remove pivot arm by gently lifting up.
7. Remove small brush belt.
8. Replace small brush belt, and reverse
steps above.
9. Manually rotate brushes by hand to make
sure they move freely. You may notice a slight
resistance from the motor.
Maintenance & Care
www.bissell.com
12
WARNING
To reduce the risk of electric shock, turn power switch
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
suction
Gate
spray
Tips
2.
2. 4.
6.
8. 7.
5.