Setting the clock – HONDA 2006 honda pilot User Manual
Page 143
−
+
If your vehicle’s battery is
disconnected or goes dead, you will
need to set the clock.
Press and hold the CLOCK (SCAN/
RPT) button. Change the hours by
pressing the H (preset 4) button
until the numbers advance to the
desired time. Change the minutes by
pressing the M (preset 5) button
until the numbers advance to the
desired time. When you are finished,
release the CLOCK button.
You can quickly set the time to the
nearest hour. If the displayed time is
before the half hour, pressing and
holding the clock button, then
pressing the RESET (preset 6)
button sets the clock back to the
previous hour. If the displayed time
is after the half hour, the clock sets
forward to the beginning of the next
hour.
For example: 1:06 will reset to 1:00
1:52 will reset to 2:00
The display shows the time when the
ignition is in the ACCESSORY (I) or
the ON (II) position.
Press and hold the SET (TUNE)
button until the numbers flash.
Change the hours by pressing the
H (
) button until the numbers
advance to the desired time. Change
the minutes by pressing the M (
)
button until the numbers advance to
the desired time. When you are
finished, press the SET button again.
Refer to the Navigation system
manual for how to adjust the time.
On models with Navigation System
EX and EX-L models
LX models
Setting the Clock
Fe
a
tu
re
s
141