BMW X5 - Manual (Page 156)

154 n Lamps and bulbs
2 Halogen high beams
H1 bulb, 55 watts
The bulb is pressurized. There-
fore, wear safety glasses and pro-
tective gloves. Failure to comply with
this precaution could lead to injury if the
bulb is accidentally damaged during
replacement.
<
1. Remove the cover
2. Disconnect the plug
3. Unhook wire spring
4. Remove and replace the bulb.
530de359
3 Parking and standing lamps
10 watt bulb: H 10 W
1. Remove the cover
2. Disconnect the plug
3. Turn reflector module with bulb to
left and remove
4. Replace module with bulb.
Xenon lamps *
The operating life of these lamp units
is extremely long and the likelihood of
failure very low, provided that they are
not switched on and off a very great
number of times. If one of these bulbs
should nevertheless fail, it is possible
to continue driving with great caution
using the fog lamps, provided traffic
laws in your area do not prohibit this.
To avoid risk of potentially fatal
injuries: owing to the extremely
high voltages at which these units oper-
ate, service work should always be
entrusted to qualified personnel.
<
Front turn signal indicators/
side-marker lamps
S 8 bulb
Please contact your BMW Sports
Activity Vehicle center in case of a
malfunction.
Side turn signal indicators
5 watt bulb: W 5 W or WY 5 W *
1. Use finger pressure against the rear
end of the lamp, refer to arrow, to
press it forward for removal
2. Apply gentle pressure to the bulb
while turning it to the left and pull it
out
3. Replace the bulb.
530de304
Online Edition for Part No. 01 41 0 157 897 - © 08/03 BMW AG