Onboard tool kit, Windshield wiper blades, Lamps and bulbs – BMW 2006 bmw 325i User Manual

Page 158

158

The onboard tool kit is located in the
luggage compartment lid.

Loosen the wingnut to open.

460de066

1 Rotate the wiper arm completely out

from the windshield

2 Position the wiper blade at an angle

and pull the release spring (arrow)

3 Fold the wiper blade down and

unhook it toward the windshield

4 Pull the wiper blade past the wiper

arm toward the top

5 Insert a new wiper blade and apply

pressure until you hear it engage.

Use only wiper blades approved
by BMW.

460de56

The lamps and bulbs are essential
factors contributing to the safety of your
vehicle. For this reason, follow the
instructions below carefully when
replacing a bulb. If you are not familiar
with any of the procedures, consult
your BMW center.

Do not touch the glass portion of
a new bulb with your bare hands

since even small amounts of impurities
burn into the surface and reduce the
service life of the bulb. Use a clean
cloth, paper napkin, or a similar mate-
rial, or hold the bulb by its metallic
base.

A replacement bulb set is available from
your BMW center.

Whenever working on the elec-
trical system, switch off the elec-

trical accessory you are working on or
disconnect the cable from the negative
terminal of the battery. Failure to do this
could result in short circuits.
To prevent injuries and damage,
comply with any instructions provided
by the bulb manufacturer.

Onboard tool kit

Windshield wiper blades

Lamps and bulbs