Craftsman 919.167551 - Manual (Page 3)

3 - ENG
SAFETY GUIDELINES - DEFINITIONS
This manual contains information that is important for you to know and
understand. This information relates to protecting YOUR SAFETY and
PREVENTING EQUIPMENT PROBLEMS. To help you recognize this
information, we use the symbols below. Please read the manual and pay
attention to these symbols.
Indicates an
imminently hazardous
situation which, if not avoided, will
result in death or serious injury.
Indicates a potentially
hazardous situation
which, if not avoided, may result in
minor or moderate injury.
Indicates a potentially
hazardous situation
which, if not avoided, could result in
death or serious injury.
Indicates a practice
not related to
personal injury which, if not avoided,
may result in property damage.
IMPORTANT SAFETY INSTRUCTIONS
This product contains chemicals known to the State of
California to cause cancer, and birth defects or other
reproductive harm. Wash hands after handling.
Some dust contains chemicals known to the State of California
to cause cancer, birth defects or other reproductive harm such
as asbestos and lead in lead based paint.
To reduce the risk of injury, read the instruction
manual.
SAVE THESE INSTRUCTIONS
SPECIFICATION CHART
Model No. 919.167551
Running HP 1.6*
Bore 2.875" (73.0 mm)
Stroke 1.45" (36.8 mm)
Voltage-Single Phase 120V/60HZ
Minimum Branch Circuit Requirement 15 amps
Fuse Type Time Delay
Air Tank Capacity 15 gallons (56.8L)
Approx. Cut-In 160 psi
Approx. Cut-out 200 psi
SCFM @ 90 psig 5.0 *
Noise Level 80 dBA **
* Tested per ISO 1217
**Tested per ISO 3744: 1994
NOTE: Refer to Glossary for abbreviations.
Declared Noise Emission Values per ISO 3744
Noise Emission Values
Sound Pressure Level: LpA = 78.0 dBA re 20μPA
Uncertainty in the Sound Pressure Level: KpA = 3.0 dBA re 20μPA
Sound Power Level: LwA = 92.0 dBA re 1 pw
Uncertainty in the Sound Power Level: KwA = 3.0 dBA re 1 pw
The sum of the emission value and the uncertainty is the limit below which there
is a 95% confidence the value of a single tool will lie below when the tool is new.