BE Pressure supply 270cc Honda GX270 B389HC - Manual (Page 18)

18
6. Uncoil high pressure hose and attach quick connect end of hose to
base of spray gun. Pull down on collar of quick connect, slide onto
spray gun and let go of collar. Tug on hose to be sure of tight
connection.
7. Similarly, attach other end of high pressure hose to high pressure
outlet (A) on pump. Pull down on collar of quick connect, slide onto
pump and let go of collar. Pull on hose to be sure of tight connection.
8. Turn Water Supply on, point gun in a safe direction and squeeze the
trigger to purge the pump of air and debris. Do this for at least 30
seconds.
9. Take a look at all connections to make sure there are no leaks or loose
connections.
IMPORTANT: DO NOT siphon standing water for the water supply. Use
ONLY cold water (less than 100°F).
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER connect high pressure hose to nozzle extension.
• Keep high pressure hose connected to pump and spray gun while
system is pressurized.
• Always be certain spray gun, nozzles and accessories are correctly
attached.
starting your washer
A
A
B
B
axial pump triplex pump
Pump Uses 30W Non-Detergent Mineral Oil