Amico Regal Series Recessed Vertical Flatwall - Manual (Page 2)

Note
Before Installation
Flatwall installation should conform to local building codes
Review a copy of the final approved shop drawing(s) and/or submittal package. These
documents will provide you with technical information specific to your installation, such as:
- equipment types and quantities
- room numbers and location
- shop drawings of each unit type
- wiring diagrams and rough-in locations
Locate the flatwall unit from the shipping boxes that you wish to install. The contents of each
shipping box are listed on the shipping document(s).
Ensure that studs are located according to Figure 1 or Figure 2 , depending on the width of the
flatwall.
Ensure that drywall thickness is 0.625”.
The installation instructions provided is for the Amico standard products.
Slight modifications to the installations may be required. The product
shipped to the job site may not be exactly as shown on the installation
drawings.
1.
2.
3.
4.
1 Amico Architectural
MAX 53”
19”
HEADWALL
MAX 48”
14”
HEADWALL
Figure 1 Figure 2