Crimestopper Security Products SP-100 - Manual (Page 12)

12
OPERATING INSTRUCTIONS Cont.
ACTIVE RE-ARMING ( FAIL SAFE PROTECTION )
The Active Re-Arming feature allows the system will Re-Arm itself 40 seconds after being disarmed with the
transmitter if a door has not yet been opened. This is handy if the vehicle is accidentally disarmed (via the
transmitter in your pocket) without you knowing it. This feature can also be turned ON or OFF in programming
(option #5).
ALARM TRIGGERING
If there is an intrusion into the vehicle or hard impact to the body will sound the alarm and flash the lights for
45 seconds. After 45 seconds the siren and lights will stop, but the alarm is still armed to continue to protect
the vehicle. If an intruder left the door open, the unit will cycle a second time before stopping and then
continue to protect the other un-tampered zones of the vehicle.
ALARM TRIGGER RESET
If the armed alarm system is triggered while you are within the range of the remote, pressing Button #1, 2 or 3
will only shut off the siren and lights while leaving the alarm still in an armed state. To Disarm the Alarm when
it is in a triggered state, you must press the #2 Button twice.
CAR FINDER MODE
When the alarm system is armed, press Button #1 (Lock Symbol). The siren will chirp once and the lights will
continue to flash 10 times.
SILENT CAR FINDER MODE
When the alarm system is armed, press Button #3 (Silent X Symbol). The parking lights will flash 10 times.
REMOTE PANIC PROTECTION
To sound the alarm upon command (panic), press and hold Button #1 for at least 3 seconds until the siren
sounds. Press Button #1 again to reset panic mode.
TRUNK HATCH POP (OPTIONAL )
To Pop the Trunk (if optional feature is installed ), press Button #4 (Trunk Symbol) on the transmitter for at
least 1 second. If the system is armed, pressing Button 4 may or may not trip the alarm system when opening
the trunk depending on programming option #7. See page 8.