Great Plains P13114 2009 Operator Manual - Manual (Page 30)

CultiPress
Operating Instructions
30
5. Servicing and Maintenance
5.8 Operator Support
If you have a problem, please contact your
dealer. They will endeavour to solve any
problems which may occur and provide you
with support at all times.
In order to enable your dealer to deal with
problems as quickly as possible, it helps if
you can provide them with the following data.
Always state the:
• Customer Number
• Name and Address
• Machine Model
• Serial Number of Machine
• Date of Purchase and Operating Hours
• Type of Problem
5.9 Maintenance Intervals
Apart from daily maintenance, the
maintenance intervals are based on the
number of operating hours and time data.
Keep a record of your operating hours to
ensure that the specified maintenance
intervals are adhered to as closely as
possible.
Never use a machine that is due for
maintenance. Ensure that all deficiencies
found during regular checks are remedied
immediately.
Avoid sharp-edged and pointed
parts (disc blades, etc.) when
working on the machine.
Place the machine on suitable
supports when working
underneath! Do not work under a
machine which is not supported!
5.7 Preparation for
Storage
If you need to store the machine for a longer
period, observe the following points:
• Park the machine undercover if possible.
• Protect the roll / discs against rust. If you
need to spray the implements with oil, use
light biologically degradable oils, e.g. rape
oil.
Cover any rubber sections before
using oil sprays. These sections
must not be oiled.
Remove any traces of oil with a
suitable cleaning agent.
5.5 Tines
When performing maintenance
work on tines extreme care should
be taken. Wear goggles and
gloves at at all times maintaining
tines.
Safely support unfolded machine in
raised position using taps and
stands before attempting
maintenance work on tines.
Fig. 5.00: Knock-on Tine Point Removal Tool
Н Н Н Н Н
STRIKE WITH
HAMMER
ENGAGE POINT
REMOVAL TOOL
5.6 Levelling Boards
Safely support unfolded machine in
raised position using taps and
stands before attempting
maintenance work on levelling
boards.