beautypg.com

Drive train operation – Great Plains 1006NT Operator Manual User Manual

Page 29

background image

1/3/07

150-285M

27

Adjustments

Drive Train Operation

Refer to Figure 19

Check all chain idlers at beginning of each season
for proper adjustment. Check that each idler is
taking up excess chain slack. The access door is
located on the top side of the gage wheel arm
near the pivot end.

After first 100 hours of use and at beginning of
each season, readjust idler sprocket in left wheel
arm. To access idlers, remove access door.

Refer to Figure 20

To adjust idler sprocket, move top idler sprocket
(1) down into chain by loosening jam nut and
screwing in adjustment stud (2). Retighten jam
nut to maintain idler position.

NOTE:

Do not overtighten chains. Overtightening

chains will cause excess wear on idlers and drive
components. Be sure chain is installed with the
chain connector link retainer towards the center-
line and the clip opening (split end) faces the op-
posite way of the chain travel.

Figure 19

Access Door

Figure 20

Idler Sprocket Adjustments

21781

21782

This manual is related to the following products: