Great Plains AS-20 Operator Manual - Manual (Page 7)

-
5 4/8/04 Great Plains Mfg., Inc.
Section 2 Assembly Instructions & Set-Up
All Seeds Hitch Flat Fold Marker 113-476M
All Seeds Hitch Marker
Installation Instructions
NOTE: While using the following text to install your
flat fold marker, you may need to refer back to the
parts section of this manual for more details and for
positive identification of related items not mentioned
in these instructions.
Refer to Figure 2-1 for Installation Instructions steps 1,
2, and 3.
1. Lower the hitch to field position. Allow clearance of
9’ on a 15’ drill and 11’ on a 20’ drill from each end of
the coulter tool bar for marker assembly.
2. Remove the outside u-bolt on the rear, left and right
hand coulter clamp. Position the left marker mount
(#1) so the outer flange can be bolted through the
coulter clamp with 5/8" x 7" bolts, lockwashers and
nuts (#2, 3 & 4). The inside flange of the mount is
fastened to the tube with a 5/8" x 4 1/32" x 6" u-bolt,
Assembly Diagram
Figure 2-1
12428