Great Plains 4000TT Operator Manual - Manual (Page 8)

4 1200-4000TT Great Plains Manufacturing, Inc.
586-201M 02/11/2014
Practice Safe Maintenance
▲ Understand procedure before doing work. Use proper
tools and equipment. Refer to this manual for additional
information.
▲ Work in a clean, dry area.
▲ Lower implement, put tractor in park, turn off engine, and
remove key before performing maintenance.
▲ Make sure all moving parts have stopped and all system
pressure is relieved.
▲ Disconnect battery ground cable (-) before servicing or
adjusting electrical systems or before welding on Turbo-
Till.
▲ Inspect all parts. Make sure parts are in good condition
and installed properly.
▲ Remove buildup of grease, oil or debris.
▲ Remove all tools and unused parts from implement before
operation.
Safety At All Times
Thoroughly read and understand the instructions in this
manual before operation. Read all instructions noted on
the safety decals.
▲ Be familiar with all Turbo-Till functions.
▲ Operate machinery from the driver’s seat only.
▲ Do not leave Turbo-Till unattended with tractor engine run-
ning.
▲ Do not stand between tractor and implement, or implement
and nurse tank, during hitching.
▲ Keep hands, feet and clothing away from power-driven
parts.
▲ Wear snug-fitting clothing to avoid entanglement with mov-
ing parts.
▲ Watch out for wires, trees, etc., when folding and raising
Turbo-Till. Make sure all persons are clear of working