Assembly – Great Plains 3000 Assembly Instructions User Manual
Page 2
2
Vansco Shaft Monitor Option 120-181M
5/8/06
Great Plains Mfg., Inc.
Assembly
Figure 5
Narrow Row Switch Mount
5.
Mount bracket and switch
(1) on feeder-cup chan-
nel using 1/2-inch-long
screws (2), flat washers,
lock washers and nuts.
NOTE: For narrow row spac-
ing drills, mount narrow row
switch mount as shown in Fig-
ure 5.
NOTE: For drills with 6-inch-
row spacing, mount bracket
so sensor end of switch is par-
allel to magnet. See Figure 6.
6.
Repeat steps to mount
magnet and switch for
other drill sections.
7.
Install shaft monitor head
(3) on tractor for operator
convenience. Use 1/4-
inch bolts, flat washers,
lock washers and nuts.
8.
Connect lead from moni-
tor (4) to a 12-volt, DC
power source.
9.
Attach ends of implement
harness (5) to switches.
Route implement har-
ness over drill frame to
tractor.
NOTE: When routing wires
avoid areas that could cut wir-
ing.
10. Plug male connector (6)
on implement harness
into female connector (7)
from monitor.
Figure 4
Assemble Switch and Monitor
Figure 6
Switch Position for 6-Inch
Row Spacing Only
17951
17950
23207