Clarion RDX455D - Manual (Page 9)

11
English
Manual memory function
1) Press the BND button , and select the
band you want to store in the memory.
2) Press the Left/Right button then select
the station you want to store in the memory.
3) Press and hold the Preset button for 2
seconds or longer, then the station will be
stored in the memory.
Auto store function (Automatic Station Store)
1) Press the BND button , then select the
band you want to store in the memory.
2) Press and hold the AS button for 2 sec-
onds or longer, then the station at which the
reception is the strongest will be automatical-
ly stored in the memory.
Note:
• When the number of stations stored is less than six,
the previous content of the memory for each direct
button will be retained.
Preset Scanning (Preset Station Scan)
When the PS button is pressed, the preset
memory numbers flash and the stations are
tuned in for 7 seconds each in the order in which
they were stored. Press the PS button again to
cancel the preset scanning mode.
Instant Station Recall (ISR)
With this function, a specific radio station can be
recalled from any mode.
ISR memory
1) Press the FNC button , then select the
radio mode.
2) Select the radio station which you want to
store in the memory.
3) Press and hold the ISR button for 2 sec-
onds or longer.
Recalling ISR
Press the ISR button
then the display will
show “ISR,” then the radio station previously
memorized will be selected. Press the ISR but-
ton
again to disengage the unit from the
Recalling ISR function.
Area Change
Use this function when you are using the car
stereo anywhere outside the U.S.
Switchable frequency spacing
This car stereo is initially set to tune in frequen-
cy intervals of 10 kHz for AM and 200 kHz for
FM, the standard calibrations in the U.S. When
using the unit outside the U.S., use the following
procedure to switch the frequency range.
The table below lists the frequency specifica-
tions for the U.S. and other countries.
Switching the area change
Outside U.S. (New Setting)
While pressing the BND button
, press the RPT
button , then “outside U.S.” will be selected.
Inside U.S. standard (Initial Setting)
While pressing the BND button , press the
RDM button , then the “U.S. standard” will be
selected.
13
16
14
16
AM
FM
Frequency
spacing
Frequency
range
Frequency
spacing
Frequency
range
Initial Setting
(U.S. standard)
New Setting
(outside U.S.)
10 kHz
530 to
1,710 kHz
200 kHz
87.9 to
107.9 MHz
9 kHz
531 to
1,629 kHz
50 kHz
87.5 to
108 MHz
7
7
7
3
5
6
16
9
18
16