Great Plains 2SNT30 Assembly Instructions - Manual

1
Installation Instructions
Great Plains Mfg., Inc.
© Copyright 1999 Printed 5/11/07
Used with:
•
197-151M
2SNT24 and 2SNT30
Replacement Gearbox
1994 & Earlier Two-Section No-Tills
General Information
These instructions explain how to install the replacement gear-
box. This gearbox replaces factory gearboxes on two-section,
no-till drills built in 1994 and earlier.
These instructions apply to:
197-150A GEARBOX REPLACEMENT KIT LH
197-153A GEARBOX REPLACEMENT KIT RH
Manual Update
Refer to the drill operator’s manual for detailed information on
safely operating, adjusting, troubleshooting and maintaining the
gearbox. Refer to the parts manual for part identification.
• 1994 Two-Section NT Operator’s Manual. . . . . . 196-117M-A
• 1993 Two-Section NT Operator’s Manual. . . . . . . .196-117M
• 1992 Two-Section No-Till Operator’s Manual . . . 196-074M-A
• 1994 and 1993 Two-Section NT Parts Manual . . . . 196-117P
• 1992 Two-Section No-Till Parts Manual . . . . . . . . . 196-074P
Before You Start
On page 3 are detailed listings of parts included in the gearbox
packages. Use these lists to inventory parts received.
Assembly Instructions
The following instructions and illustra-
tions are for the left-hand drive. If install-
ing gearbox on right-hand drive, follow
these instructions, remembering that
your parts will mirror the illustrations.
1. Remove chain (1) from gearbox to
seed-cup sprocket. Save chain for
later reinstallation.
2. Remove and discard bolts (2) hold-
ing gearbox (3) on gearbox shelf (4).
Remove and discard gearbox and
gearbox cover.
When you see this symbol, the subsequent instructions and
warnings are serious - follow without exception. Your life and
the lives of others depend on it!
!!
18096