Great Plains Simba Culti Press Operator Manual - Manual (Page 35)

35 Simba CultiPress
608-206M-ENG
2013-02-04
6. Faults and Remedies
6. Faults and Remedies
Simba CultiPress Troubleshooting
Fault
Possible Cause Remedy
Front roll axle starts to
block regularly.
Machine running too tail
low.
Shorten work drawbar
cylinder until chassis is
horizontal or just tail low.
Reduce quantity of shims in
depth stop unit.
Front to rear tracking out of
alignment.
Reset ring centres to run
rear rings centrally between
the front rings.
Roll axle is not tight. Tighten axle.
Ground conditions too wet. Wait for more suitable
ground conditions.
Rear roll axle starts to
block regularly.
Machine running too tail
high.
Lengthen work drawbar
cylinder until chassis is
horizontal or just tail low.
Increase quantity of shims
in depth stop unit.
Roll axle is not tight. Tighten axle.
Front to rear tracking out of
alignment.
Reset ring centres to run
rear rings centrally between
the front rings.
Ground conditions too wet. Wait for more suitable
ground conditions.
Rear roll scrapers incor-
rectly adjusted.
Set scrapers to run just
clear of rings and centrally
between each ring.
Levelling boards drop at
headland turns.
Tractor spool valve in float
position.
Operate levelling boards
using pressure only.
Levelling boards become
unphased.
Tractor spool valve in float
position.
Operate levelling boards
using pressure only.