Wheatheart X13 Reverser Kit User Manual
Page 2
2
Figure 1 Locating Reverser Bolt Holes
6. Install the splined coupler on the flight shaft using a 3/8" x 1-3/4" square key
and a 3/8" roll pin.
7. Install the new sprocket shield using the original four 5/16" x 3/4" bolts (see
Figure 3). Discard the old sprocket shield.
8. Attach the new (longer) PTO saddle to front of boot face with two 1/2" x 1-1/2"
bolts and locknuts.
9. Adjust the boot tow bar to use the appropriate hole (labeled “Reverser Hole”
in Figure 3), and attach using the existing 3/4" x 5-1/2" bolt and locknut.
Tighten securely.
10. Install the splined stub shaft on the PTO driveline using a 3/8" x 1-3/4" square
key and 3/8" roll pin. Use a thread locking compound on setscrews to install
and tighten them securely.
CAUTION
Protect your eyes when tapping in the roll pin.
X
Y
9”