beautypg.com

Adjust the spring tension, General operating instructions – Harbor Freight Tools AUTO-REWIND AIR HOSE REEL 95211 User Manual

Page 5

background image

Page 5

For technical questions, please call 1-800-444-3353.

Item 95211

Operating instructions

Read the entiRe imPORtant SaFetY inFORmatiOn section at the beginning of this

manual including all text under subheadings therein before set up or use of this product.

inspect tool before use, looking for damaged, loose, and missing parts.

if any problems are found, do not use tool until repaired.

adjust the Spring tension

1. Pull out approximately six feet of Hose.

2. Remove the Hose Stopper from the

Hose and slide the Hose out of the Roller

Guide so the Hose is hanging loose.
a. To increase tension, wrap the loose hose

one time around the Reel Drum.

b. To decrease tension, unwrap the

hose one time from the drum.

3. Run the hose back through the guide

and re-attach the hose stopper.

4. Pull the Hose out several feet to check the tension.

CautiOn: When adding wraps of hose, do not

exceed the winding mechanism’s spring capacity.

Add just enough wraps of hose to achieve the

desired tension. Damage to the winding mechanism

will result if spring is over-tensioned.

General Operating instructions

1. Check the Wheel operation by slowly pulling the

Hose out. You should hear a clicking noise.

2. To lock the Hose, pull it out a minimum

of 1/2 revolution and it will stay locked

after the first, second, or third click.

3. To unlock, slowly pull until the clicking stops, and let

it retract until the Hose Stopper hits the Hose Guide.

CautiOn: Hold on to the Hose while it is

rewinding to avoid damage to the Hose Reel.

4. Attach a coupler (sold separately) to your

air compressor hose and apply thread

seal tape to the Inlet fitting on the Reel.

Connect the coupler to the Inlet fitting.

5. Connect your air tool to the other end of the Hose

using another coupler and thread seal tape.

6. Follow all instructions from the air tool

and compressor for set up and use.

7. When finished using the Hose, disconnect

the air tool and retract the hose. Wipe the

Hose Reel clean with a dry cloth.

Sa

Fet

Y

O

Pe

R

ati

O

n

m

aintenan

C

e

Setu

P