beautypg.com

Desa Tech Comfort-Glow Freestanding Electric Fireplace EF5802R User Manual

Page 4

background image

-4 -







WARNING: This is a 1500 watt heater and parts become hot when in use. Be sure to maintain
a personal distance and keep any combustible material at least three (3) feet away from
the front of the heater. The area directly behind, around and under the heater must be clear
and free of any obstructions.

KEEP CHILDREN AND PETS AWAY FROM HEATER AND CONTROLS

LOCATING YOUR ELECTRIC FIREPLACE

Your new freestanding electric fireplace may be installed virtually anywhere in your home.
However, when choosing a location for your new electric fireplace, ensure that the general
instructions are followed. For best results, install the electric fireplace out of direct sunlight.










ELECTRICAL CONNECTION

A 15 AMP, 120 Volt, 60Hz circuit with a properly grounded outlet is required. Preferably, the heater will

be on a dedicated circuit. Other appliances on the same circuit may cause the circuit breaker to trip or

the fuse to blow when the heater is in operation. The unit comes standard with a 6' (1828mm) long

three wire cord exiting from the rear of the fireplace. Plan the installation to avoid the use of an

extension cord. If an extension cord must be used, it must be a minimum 16 AWG three wire with

grounding type plug connector and rated no less than 1900 Watts.











WARNING: Procedures and

techniques, which, if not

carefully followed, will expose

the user to the risk of serious

injury, illness or death.

WARNING: Procedures and

techniques, which, if not

carefully followed, will result

in damage to the equipment

or personal property or may

cause personal injury.

CLEARANCE TO COMBUSTIBLES

Back………….…0"/0mm
Sides……………0"/0mm
Floor…….………0"/0mm
Top…….........….24"/610mm
Front..................36”/915mm

ELECTRICAL SPECIFICATIONS

Voltage................120 VAC/60Hz
Total Amps...........11.3 Amps
Total Watts...........1500 Watts
Heater Ratings.....1400 Watts (+5%, -10%)

WARNING: Electrical

outlet wiring must comply with

local building codes and all

other applicable

regulations to reduce the risk

of fire, electrical shock and

injury.

WARNING: Do not use this

fireplace if any part of it has

been under water. Immediately

call a qualified service

technician to inspect the

fireplace and replace any part

of the electrical system if

necessary.