CITIZEN HYPER AQUALAND MA9XXX User Manual

Page 4

The dot display symbols and their meaning

: Time calendar mode
: Alarm mode
: During the measurement of temperature
: Log mode (The display when there is no

profile data recorded)

: Log mode (The display when profile data

has been recorded)

: Surface mode (Time elapsed after

completing a valid dive)

: Transfer mode
: Data presently being transferred

: Dive mode (Diver is swimming)

: Ready for diving

Warning Display

: Ascending speed warning

: (D201/D207) /

(D202/D208): Battery Warning

: Various checks (*without (D202/D208))

: Various errors

*Please look at the N. [The log mode] for an
explanation about profile data.

G. How to change the mode
The mode changes by pressing button

ࠗ

or when

the water sensor gets wet.

* Surface mode cannot be acquired unless a valid

dive is done.

* Change to the transfer mode by pressing the

ࠗ

button for more than 2 seconds from any mode.

*Change to the transfer mode by pressing

ࠗ

button

for more than 2 seconds from any mode.

ࠗ

: Press (M) button once

ࠗ

: Press (M) button for more than 2 seconds

: Displayed only in surface mode
: Auto return

H. Time and calendar mode
[This is the function which displays present time and
present calendar.]
• In normal time mode, a LED, which is situated at

12 o’clock, flashes a time signal for 3 seconds on
every hour. (ex 7:00:00, 01, 02)

• By pressing

ࠗ

button in the time and calendar

mode, the watch is in temperature measuring state
(1st temperature display state). In this mode the
temperature is measured every 10 seconds for 3
minutes. However, until the first measurement is
taken it displays [--°C].

• After 3 minutes the watch automatically changes to

(the 2nd temperature display state) where
temperature is measured every 30 minutes. The
range of temperature measurement is between –
5°C to 40°C (23°F~104°F). However, while the
watch is on your wrist the correct temperature
cannot be measured properly, so please remove
the watch from your wrist to get accurate readings.

• In the time and calendar mode, you can confirm

the LED flashes by pressing the

ࠗ

button once.

(Flashes 5 times)

• The display light will stay on for up to 10 seconds

while you press

ࠗ

button. The display light will

switch off 1.5 seconds after releasing the

ࠗ

button.