SCANTECH ID (Champtek company) Pollux P-4010 - Manual (Page 20)

Installation 14
Changeable power plugs
To change the power plug suited to your area, follow the steps below:
1. Press and hold the tab on the AC power adapter.
2. Remove the changeable plug outwards.
3. Replace with the desired power plug.
2.5 INITIALIZING
When using this scanner for the first time, you need to initialize the
communication parameters first. Follow the steps below to initialize:
1. Ensure that the desired interface cable is connected to this scanner and
your host system.
2. Power up this scanner.
3. Initialize the communication parameters by scanning the programming
barcode 1.1 and 1.3 on the Configuration Guide.
NOTE
The procedure is required only once. However, when changing
the cable from one type to another, you need to perform the
procedure again.
KBW mode
In KBW (Keyboard Wedge) mode, the scanner defaults to the International
Keyboard layout (ALT-method) for communication.
NOTE
To change the settings to national keyboards in KBW mode,
refer to section 3.4 on the Configuration Guide.