ZPC 9005SSMV - Manual (Page 4)

3
ASSEMBLY INSTRUCTIONS
Fasten mounting brackets (BB) to shelf (A) and towel
bar (B) with hex-head screws (AA).
1.
Fig. 1
BB
Hardware Used
x 4 Hex-Head Screw AA
AA
B
A
x 2 Mounting Bracket BB
Hold the unit at the desired position on the wall.
NOTE: Make sure the unit is level.
Mark mounting points on wall through holes in the
mounting brackets (BB). Hammer wall anchors (CC) into
wall, unless mounting screws (DD) will go directly into a
stud.
NOTE: Do not use a wall anchor if mounting screw will
be going into a stud.
Wall anchors (CC) should be oriented with the flat side
horizontal. Place unit against wall, lining up holes in wall
and holes in mounting brackets (BB). Complete mounting
by tightening mounting screws (DD) into studs or wall
anchors (CC).
2.
Fig. 2
Hardware Used
x 4 Wall Anchor CC
CC
DD
x 4 Mounting Screw DD
IS9006-I5
BB
Printed in China