Winchester Repeating Arms Supreme (Historic Manual) User Manual

Page 19

3. Visually check to make sure there are not obstructions,
grit, grime, oil, cleaning patches or other materials in or
around the action area or in the chambers or bores of the
barrels.

CAUTION: EVEN THE SMALLEST OBSTRUCTION CAN
INCREASE BARREL PRESSURE. THIS MAY RESULT IN
BARREL DAMAGE AND SERIOUS INJURY TO THE
SHOOTER AND OTHERS IN THE VICINITY.

4. Insert a shell in the chamber or chambers you plan to
fire. Make sure they are fully forward in the chamber(s),
with the rims in direct contact with the edge of the
extractors/ejectors (See Figure 14).

CAUTION: MAKE SURE THE SHELLS ARE OF THE
PROPER GAUGE AND CHAMBER LENGTH FOR YOUR
GUN. CHECK THE AMMUNITION DESIGNATION ON THE

BARREL AND CHECK THE DESIGNATION ON YOUR
AMMUNITION. FAILURE TO FOLLOW THESE INSTRUC-
TIONS CAN RESULT IN SEVERE DAMAGE TO YOUR
GUN AND POSSIBLE SERIOUS INJURY TO YOURSELF
OR OTHERS.

5. Close the action by lifting up on the forearm, hinging
the barrels upward into position, until the action is fully
closed. When closed the top lever will snap back into the
center position. There should be no space between the
face of the barrels and the face of the receiver when the
action is fully closed (See Figure 15).

It is common, because of the tight tolerances and crafts-
manship of your shotgun, that the top lever will be just
slightly right of center, even when the action is fully
closed (See Figure 16). This is the result of tight

FIGURE 15

Make sure the action is fully closed. The barrels should
be tight with the receiver at the breech.

FIGURE 16

When closed, the
top lever may
still be slightly
to the right.

Supreme Manual 01/01 7/17/03 11:00 AM Page 17