Campbell Hausfeld SB524000 - Manual (Page 7)

7
SB524000
www.chpower.com
Maintenance TOOl RePaIR
Only qualified personnel should repair
the tool, and they should use genuine
Campbell Hausfeld replacement parts
and accessories, or parts and accessories
which perform equivalently .
aSSeMBly PROCeDURe FOR SealS
When repairing a tool, the internal
parts must be cleaned and lubricated .
Parker O-lube or equivalent must be
used on all o-rings . Each o-ring must be
coated with O-lube before assembling .
A small amount of oil must be used on
all moving surfaces and pivots .
After reassembling, a few drops of 30W
non-detergent oil or equivalent, must
be added through the air line before
testing .
Storage
The unit should be stored in a cool, dry
place .
TeChNICal SUPPORT
Please call our Tool Hotline at 1-800-
543-6400 with any questions regarding
the operation or repair of this tool or
for additional copies of this manual .
FaSTeNeR aND RePlaCeMeNT
PaRTS
Use only genuine
Campbell Hausfeld
18 gauge fasteners (or equivalent - see
Fastener Interchange Information).
Tool performance, safety and durability
could be reduced if improper fasteners
are used. When ordering replacement
parts or fasteners, specify by part
number.
Notes