Waring WEB300 - Manual (Page 5)

4
OPERATION
Before plugging in your extra burner, check to ensure that the electrical
circuit is not overloaded with other appliances. This unit should always
be operated on a separate 120 volt 60 Hz AC circuit. Be certain that
your extra burner is resting level on the countertop. There is one burner
ring on the WEB300 and two burner rings on the WDB600. The large
burner plates are rated at 1300 watts. The smaller burner is rated at
500 watts. Use the larger burner for fast cooking, such as boiling water,
and use the smaller burner for simmering or warming. Note: Avoid using
pans that are unstable and easily tipped.
1. Place unit on a flat surface.
Note: Be sure to place unit in a safe area and leave 4 to 6 inches
of space above and around the unit for proper ventilation.
2. Plug unit into electrical outlet. Turn temperature control dial(s)
from Off to desired setting. Caution: Do not touch burner
while in use.
3. You can choose a temperature setting from 1 to 5.
Setting 1 — Low
Setting 2 — Low/Medium
Setting 3 — Medium
Setting 4 — Medium/High
Setting 5 — High
Note: When extra burner reaches desired temperature,
the green “ready” indicator light will illuminate. Your burner
is now ready for use.
4. When using a pot or pan, place it in the center of the burner.
It is recommended that you use a pot or pan that is the same
size as the burner.
5. When cooking is complete, turn temperature control dial(s)
to the Off position.
6. When not in use, unplug unit to assure that it is off. This helps
prevent accidental burns.