Valco Baby Twin Latitude Maxi Cosi Car Seat Adaptor - Manual (Page 2)

B
D
INsTALLINg yOUR TwIN MAXI
COsI CAR sEAT ADAPTOR:
FIgURE A
1. Begin preparing the Latitude stroller for the
Car seat Adaptor by removing the canopy (hoods)
from the stroller and reclining the seats to their
fully reclined position (detailed instructions in the
Twin Latitude stroller Instruction Manual).
2. Remove the extra hood, Male and Female
straps and Maxi Cosi strap from the packaging
and dispose of packaging responsibly.
FIgURE B
3. The extra hood is intended to shade the seat of
the stroller being used without a car seat.
4. Prepare the Hood for installation by rotating
the hood rods so they are aligned with the
corresponding connector pieces on the stroller
frame (where the twin hood was connected.) (1)
5. simultaneously slide the hood rods onto the
corresponding raised pieces of the stroller frame
and lock into place. (2)
6. snap the hood snaps onto the corresponding
snap pieces on the stroller seat back.
FIgURE C
7. The Male and Female straps are intended to
secure the car seat to the stroller frame.
8 select a strap to secure around the side bar of
the Latitude stroller.
NOTE: ONLy sECURE THE sTRAP TO THE sIDE OF
THE sTROLLER wITHOUT THE HOOD.
FIgURE D
9. Fit the strap around the side bar of the Latitude
stroller.
A
Select a strap to secure to stroller
1
2
C
Male Buckle
Female Buckle
Maxi Cosi Strap
Hood
Seat Reclined
Bumper Bar
Wrap the strap around side bar