Valco Baby Zee Two User Manual

Page 4

FIGURE H - BUMPER BAR

19. Insert the front bar ends into the nylon housings

located on either side of the frame. Be sure that the

moulded arrows are facing forward, away from the frame.

Be sure that the bar is securely engaged.

20. Wrap the crotch strap around the installed bumper bar

and snap into position

21. Adjust the front bar by simultaneously pressing the

button on the bar housing and swivelling the bar to the

uppermost position. This is the only position for use

with a child in the stroller.

22. To remove the front bar: Feeling the side of the nylon

housing that sits below the frame at each side (facing

inward), locate the release button.

23. Press each release button inward while simultaneously

pulling upward on the bar housing. Repeat for the other

side. Note that this may be difficult to do as the bar is

secured firmly as a safety precaution.

IMPORTANT WARNING: THE FRONT BAR IS NEITHER A

RESTRAINING NOR CARRYING DEVICE.

FIGURE I - SEAT RECLINE

Our system offers an almost infinite amount of individual

seat adjustments.

24. TO RECLINE: While squeezing the centre release

mechanism in a pincer action, ease the seat down to the

desired position.

25. TO INCLINE: Place your hand at the centre of the rear

of the seat. Pull the incline strap while gently pushing on

the rear of the seat until the desired position has been

reached.

FIGURE K- ADJUSTING YOUR FOOTREST

26.To adjust your foot rest downward, press the central

buttons on either side of the footrest while

simultaneously adjusting it up or down.

YOUR FOOTREST IS DESIGNED TO COLLAPSE IF EXCESS

WEIGHT IS APPLIED TO IT

FIGURE L

Each Expanda hood unzips, increasing the size of the

standard hood to give it greater coverage and protection

from the sun and weather for your child.

To open the Expanda Hood:

27. Locate the zip in the center of the Expanda Hood and

unzip completely

28. Gently pull the Expanda Hood forward until it is reaches

its full extension.

To close the Expanda Hood:

29. Gently push the Expanda Hood back, allowing the

middle section to fold in on itself.

30. Carefully zip the Expanda Hood closed.

PRESS

PULL

click

IMPORTANT HOOD INSTALLATION INSTRUCTION

The Expanda hoods come fixed to the stroller.

Secure the rear hood skirt to the frame

by passing the press stud through the slot

provided and firmly engaging the other half by

pressing strongly. Always test that the press

studs are fully and firmly engaged.

▲

HOOD SKIRT

SEAT SIDE