Valco Baby Snap - Manual (Page 6)

1>PARTS LIST
Stroller frame with hood attached, 2x rear
wheels, 1x front dual swivel wheel, 1x
bumper bar.
2>TO OPEN
Release the frame lock (a) by pulling it clear
of the locking pin.
Lift the handle in one continuous motion while
allowing the legs to simultaneously open.
Continue until the frame locks fully open.
IMPORTANT WARNING: ALWAYS TEST
THAT ALL LATCHES ARE SECURELY
ENGAGED BEFORE USE.
3>REAR WHEELS
While depressing the button (b) at the rear
axle junction, insert the rear wheel axle into
the rear axle tube of the stroller. Push the
axle into the tube as far as it will go before
releasing the button.
Repeat for other wheel.
To release your wheel, press button (b) and
pull from axle tube.
IMPORTANT: TEST THAT EACH WHEEL
HAS FULLY ENGAGED IN THE FRAME
TUBE BEFORE USE BY PULLING ON IT.
To use the rear brakes:
Press down on the right side of the red
brake lever located on the rear axle to
simultaneously engage the brake in both
rear wheels.
To release, press down on the left side of the
red brack lever with your foot.
IMPORTANT WARNING: ALWAYS TEST
THAT THE BRAKES ARE SECURELY
DISENGAGED BEFORE USE.
4>FRONT WHEELS
Align each front wheel pin (c) beneath the
housing (d) on each front leg of the stroller.
Be sure that the pin engages securely in the
channel
IMPORTANT: ALWAYS TEST THAT THE
WHEEL HAS SECURELY ENGAGED IN THE
CHANNEL BEFORE USE. ENGAGED THE
CORRECT WAY UP
To fix the front wheel in the non-swivel
position: Turn the wheel so that the notch at
the front of the wheel channel (e) lines up
with the one in the top plastic housing (f).
Press down firmly on the tab until it locks
into place.
5>TO FOLD
Press down on the secondary lock button
(g) - it will stay down. Squeeze the fold
button in the handle (h), moving the handle
forward slightly.
Grasp the folding handle (i) allowing the
handle to move all the way forward till the
frame automatically locks shut (j).
Your SNAP stroller can stand unaided for
easy storage.
HINT: WHILE NOT NECESSARY FOR
FOLDING, MOVING THE SEAT BACK
FIRST TO THE MOST UPRIGHT POSITION
AND FORWARD THROUGH THE FRAME
WILL MAKE FOR THE MOST SIMPLE AND
COMPACT FOLDING.
6>BUMPER BAR
Insert each side of the bumper bar fitting
into the corresponding housing in the seat
frame until yo ce.
The bumper bar can be opened as a “gate”
for easy access pressing on one of the
release buttons (k) and lifting the side out
of the housing. For full removal, repeat this
process for the other side.
7>SEAT RECLINE
To recline: While squeezing the seat adjuster
tabs (l) together in a pincer like movement,
ease the seat down to the desired
position. Release the tabs and the seat will
automatically lock in that position
To incline: Place your hand in the centre of
the seat at the rear.
Pull the incline strap (m) while gently pushing
the seat upward to the desired position.
INSTRUCTIONS