Valco Baby Bassinet - Manual (Page 2)

Thank you for purchasing a quality VALCO product. Due to our policy of continuous product
development, this model is constantly evolving. It is possible that some features or procedures
outlined here have changed since this document was written. If you are unsure of any procedure
outlined here please contact the store from which you purchased it to obtain the most up to date
information, or contact us via the internet. See relevant web contact addresses on the back page.
PREPARING FOR / INSTALLING / REMOVING YOUR BASSINET
Remove the bassinet from the carton and dispose of all packaging immediately and thoughtfully.
1. Remove the seat fabrics and bumper
bar from your RUNABOUT stroller.
2. Inside your bassinet package you will
find a set of 2 plastic locking pieces.
3. With the release buttons facing
inward, insert each locking piece in
turn into the plastic housing on
either side of the stroller frame.
1. Standing at the side of the
chassis and holding the bassinet
at both sides by the plastic hand
holds; tilt the bassinet slightly
toward you.
2. Gently slide the bassinet housing
just over the plastic locking piece
closest to you in the chassis.
3. “Line up” the other side and
repeat step 2.Press down gently
on the bassinet and it will slide
into place.
1. To remove; holding the
bassinet by the plastic grips
on either side, simultaneously
press the two triggers
located in the grip.
2. Gently lift the bassinet from
the frame.
CARRYING YOUR BASSINET / ADJUSTING THE HOOD
Your Runabout bassinet has been
designed to be easily removed and
carried.
To carry the bassinet, grab the
padded hood bar at the top of the
hood and away you go! The hood
system automatically locks the hood
in the OPEN position, and has been
designed so that the hood will not
collapse when carried.
To fold the hood down, press down on the hood lock (one side only) to release the
hood, and simultaneously push back on the carry bar.
Your Runabout Tri Mode bassinet has a
removable (and washable) inner lining.
1. To Remove; carefully lift off the lining,
taking special care when undoing the
press studs.
2. To Replace; following the contours of
the bassinet rim, line the studs in the
lining with the corresponding studs in
the bassinet body Fold the lining over
the rim and fasten the studs carefully.
ALWAYS ENSURE THAT THE HOOD IS SECURELY LOCKED IN PLACE BEFORE CARRYING THE BASSINET.