Unitec Receipt Printer User Manual
Page 2
W A S H P A Y
Document Number:
WP1007
5. Be sure that the flange on the front of the printer is flush with the wall.
6. Align the 1" side of the L-bracket with the holes on the side of Receipt Printer.
7. Insert 1 of the provided bolts into each hole and tighten snugly. Repeat this step to secure the L-bracket to
the other side of the case.
8. Locate the three holes in the 1 1/2" side of the L-bracket that are facing the wall. Inset one of the drive
screws into each hole and tighten snugly. Repeat this step on the other side of the unit. The drive screws
will ensure that the flange on the front of the Receipt Printer fits snugly against the outer wall.
9. Plug the four-pin connector on the +24VDC external power supply to the four-pin jack located next to the
power switch on the distribution board, as shown in the following figure:
Figure 2. WashPay Receipt Printer Wiring
10. Pull a CAT5E cable from the patch panel in the office/equipment room to the Receipt Printer. The CAT5
cable should not exceed 300 feet in length.
11. Assemble the Tool-less RJ-45 connector onto the end of the CAT5 cable (follow the instructions included in
the kit or from Appendix A of the WashPay Site Server Installation Manual). Make sure to use the “B” pin-
out configuration and that it matches the pin-out configuration of the other end of the CAT5 cable that is
plugged into the patch panel.
12. Plug the existing RJ-45 plug inside the printer enclosure into the Tool-less RJ-45 connector.
13. Plug the power supply into a 115VAC outlet.
14. Plug a CAT5 cable into the printer’s corresponding port on the patch panel and plug the other end of the
CAT5 cable into the LAST port on the router or Ethernet switch (the router assigns the paynodes in
sequential sequence so that all of the wash bays will be grouped together).
Please refer to the Documents and Downloads ta
ese
additional documents:
WashPay Site Server Installation Manual
WashPay Owners Manual
Sierra Management Application Programming Manual
Document Title:
WashPay Receipt Printer Installation Instructions