Common bt 200 functions – Cobra Digital BT 200 User Manual
Page 7
8
9
Nothing Comes Close to a Cobra
®
Common BT 200 Functions
Home Button
Pressing this button enables you to return the handset to Standby mode from
any other mode.
Voice Dialing / Last Number Redial
This button serves two functions:
■
To enable voice dialing.
■
To redial the last number dialed from the handset.
Voice Dialing
You can activate your cell phone's voice dialing feature from Standby mode.
To Voice Dial A Number:
1. Press and release the Voice Dialing / Last Number Redial button.
2. Say the name or phone number command following the audio prompt.
The display screen will show the progress of dialing and connecting the call.
NOTE
Your cell phone must have voice dialing enabled and voice commands
recorded to use this feature with the BT 200.
To Redial The Last Number Dialed:
1. Press and hold the Voice Dialing / Last Number Redial button for two seconds.
The display screen will show the progress of dialing and connecting the call.
Function Buttons
The Function buttons provide different utilities to different modes of handset
operation. In any mode, the active functions are shown directly above the buttons
on the display screen as shown in this Standby display.
In this example, pressing the second button from the
left will display the Menu.
Operating Your Handset
8
English
Common BT 200 Functions
Push to Talk (PTT)
This button serves two functions:
■
To activate the handset microphone during a call when VOX is Off. This is similar
to the action of such a button on a Cobra VHF or a CB radio.
■
To activate the handset microphone for a PA announcement, the unit must be in
Standby and be connected to the stereo’s AUX input with the stereo in AUX mode.
To Activate the Handset Microphone During a Call:
1. After placing or accepting a call, press the PTT button and talk into the handset
microphone.
To Make a PA Announcement:
1. When the unit is in Standby mode, press the PTT button and talk into the
microphone.
NOTE
Before a PA announcement can be made:
■
The PA function must be turned ON from the settings menu.
■
The BT 200 must be connected to the stereo system AUX input.
■
The stereo must be in AUX mode with the stereo’s volume adjusted.
■
An optional installation cable is necessary to use the PA feature.
Green Phone Button
This button acts just like the green phone button on a cell phone. Pressing the
button answers an incoming call and initiates dialing an outbound call after the
number has been entered or selected.
In Standby mode, this button is a shortcut to the Call Log where a number can be
selected to call.
Red Phone Button
This button acts just like the red phone button on a cell phone. Pressing the button
ends an active call.
In modes other than an active call, it backs up to the Standby mode.
Operating Your Handset
VOL
MENU
LOG
CONT
PAIRED TO
XXX
Functions
Function Names
Function Buttons
BT200_MANL.qxp:10732 Cobra MR F300 BT 12/8/08 1:44 PM Page 8